I was on the search for a backplate for the ender 3 V2 for the final release of the stealthburner. since i couldnt find anything, that satisfied me, i found some other .step and made this backplate. it fits E3 (not tested) and E3V2 (tested) x-plate very well.
furthermore i wanted to use an EBB36 with my stealthburner but i cant screw it on the back of the cw2 motor, because that would restrict the movement because of the z profiles. so i also made a mount for that and a bl touch. You can also find a file for a bl touch only and Bltouch+ebb42.
Printsettings should be the same as all the other voron parts material can be PLA but i would recommend ABS/PETG
4x M3x8 BHCS
1x M3x18 BHCS + washer and nut
(goes into the only hole that has no thread on the x-carrier plate)1x M3 short heat insert
(goes into the right side)1x desired backplate
2x M3x6 BHCS
2x M3x8 BHCS
1x M3x18 BHCS
2x M3 short heat insert
(goes into the bl touch mount from the bottom side)2x/3x printed spacers
1x Mount (for either: BLT; BLT+EBB36; BLT+EBB42)
X=38,4
Y=2
Z=1.43mm
(please measure z for yourself)
The only problem i found is that the hotendcarriage is slightly in the way of one of the screws. you can see in one of the pictures, where you need to cut away a small bit of material to make it fit. it wont be bad for the function of the part. in the future i will release a recessed screwhole, but for now this works.
The last 3 pictures show our work in progress CANBurner Board.
I would really like to receive any kind of feedback on my design, because that would help me design a file, that is just plug and play.
The author remixed this model.