Runescape Coaster - Wrath Rune

Runescape Wrath Rune coaster.
13
57
0
198
updated October 15, 2022

Description

PDF

I created several coaster models based on this model.  The rest are on my profile.

I really wanted to print some Runescape themed coasters, but found that the models already out there were kind of bad.  

Print with 20% infill for best results.  PLA is fine.
Enable ironing on every layer.  I printed these before I knew about this, so I have lines where the paint is.

I highly recommend using plastidip on the bottom to create a non-slide coating.  Only one medium layer of plastidip is needed.

Use acrylic paint.  Several coats of very thin paint should give good results.  Some of mine turned out better than others.  Still need to finish painting most of them.

Attached a photo with the various colors you'll need to match with paint.

Tags



Model origin

The author remixed this model.

License