Watering bottle nozzle spout

This is a watering spout head designed to fit onto a standard drink bottle thread.

All of the watering bottle spouts i could find online had big holes and very small heads, meaning the water would come out very fast in a concentrated area, drowning seedling and throwing up soil.

This watering spout has a large 100mm head and tiny 1mm holes, this gives a thorough shower effect; the water comes out gently and covers a wide area. You'll also see that the holes are not run in parallel lines, the water leaves at an equal rate across the area of the head.

I used the thread from this design: https://www.thingiverse.com/thing:2693686

Everything else is designed from scratch.

I pushed the design to it's limit by printing with a 1.0mm printing nozzle and it held up perfectly, no leaking. Print yours with a smaller nozzle at a decent layer height and it will come out lovely! Some infill needed to reinforce the threaded area.

Happy gardening!