Rotating Display Stand - Spray Booth Turntable 150mm (6")

Rotating Display Stand - Spray Booth Turntable

150mm (6") rotating display stand for miniatures or use as an extra spray booth lazy-susan turntable for spraying models

Utilises (x12) standard 5mm ball bearings used for model paint mixing.

Use a small 3mm screw or similar. I used (4gx9) to secure the top lid to the base. Just file out a small amount on the lid, if your screw is too tight. It should be loose through the lid hole.

I used a small amount of grease to assist the bearings. I placed a 150x3mm Acrylic round top on and are using them for a rotating display stand in my glass cabinet.

Don't forget to place some small ‘non-slip’ pads under the base and acrylic top (if using), to assist with friction support.

I printed at 0.28 as it only needs to be functional and this took just over 2 hrs for each half with CHEPS - FFV5.0-ExtraFast-028 profile.