This is an alternative lighting setup for the BLV mgn cube. It uses three 15 cm LED strips in each panel. The panel attaches to the extrusion under the gantry using M3 screws and T-nuts.
The idea behind the design is to increase the brightness by adding more LED strips but also to raise the illumination as high as possible without colliding with the gantry. It doesn't really get much closer than this. However, for the first few layers the illumination is not great but it's better than the original.
Print the LED diffuser with 100% infill in clear PETG or similar. It then snaps into place in the holder.
Category: 3D Printer PartsThe author marked this model as their own original creation. Imported from Thingiverse.