Mac Keyboard Grippy Feet

This must be printed with supports. I used the default Cura supports, but I think I would have had an easier time had I gone with Tree supports. When I removed the supports, I did break a couple of the mushroom tabs off by accident, but the grippies have stayed on.

I used a clamp to press them into the mould filled with silicon caulk, then left it overnight, and gave them another hour or two to stop feeling tacky.

I used 3M stickers to adhere them to the keyboard.

The slope is ~4°, the front adds ~.25" (6.35mm) in height, and the rear adds ~.5" (~12.7mm) in height.

The pictures were taken after 3-4 months of daily use.

Category: Office