Peg Board Tape Holder

A peg board mount for your tape. Get it out of that drawer and on the wall where you can see it.

Designed for a max roll width of 50mm and minimum ID of ~35mm. Let me know if you need a custom size, it's easy to modify.

For 1/4" or 6.25mm peg holes.

A version for 5mm has also been uploaded.
A Version for mounting to the wall with screws has also been uploaded.

I've found the best way to print is with the peg board mating surface down with supports. This way the only ugly side is the one you don't see. You may have better luck with removing supports and the finishes under them than I do. I haven't had a chance to try and clean up the surface using print settings.

In this upright configuration the peg grain is non-ideal which is why I used such a high infill. This doesn't impact print time too much as the part is so small to begin with.