Designed to be printed at 0.2mm layer height in TPU & for 6mm diameter peasticks (plant supports).
Ideally for softness:
1 wall
1 Bottom
1 Top
10% infill
I have a few tender houseplants that need occasional support, so I designed this part to just gently caress the plant.
The part sits in a crook formed by two crossing peasticks and is held in place with a cable tie below, see image.
Easy to fit due to the split nature & is reusable as the plant grows.
Happy Printing ;)
Category: Outdoor & GardenThe author marked this model as their own original creation. Imported from Thingiverse.