Mintion Beagle Camera Swivel Arm mount

2x M4 bolts 15mm needed 4040 and 4020 mounts added enjoy
58
571
11
3451
updated September 18, 2022

Makes

Comments

works great. first one i printed the camera pins snapped off when i tried twisting the camera on. So i just zip tied it on temporarily until i printed SnipeX3D's remixed arm. I kept the same frame mount and just attached the remixed arm. Works perfectly now. Thanks for the great camera mount!

Perfektes Teil, genau was ichgebraucht habe.

it work on my Ender 3 Pro to thank you

Works great. I accidently tore the connection to the camera but still gets the job done. Printed in red matte PLA at 0.32 mm layer height.

Works very well!!

Good concept but could use some improvement. I printed the 4040 mount for my ender 3 pro, but it was a little looser than I would like. So I drilled a 4mm hole for a t-nut to decrease play, and this worked very well. Unfortunately, the pins of the arm weren't quite long enough, so I printed @SnipeX 3d's remixed arm instead. (edited)

Print looks great with Prusament Galaxy black, but i'm not sure how the bolts are supposed to work so i just put the screw in and it holds it

Removed the clip to make a flat face on the mount and used some 3M tape to hold it to my Mega X. Protopasta Black is the king of all black filaments. Prints insane quality and is as strong as PETG

Works Great!

Super gut, so habe ich mir den Halter vorgestellt. Vielen Dank für deine Arbeit.