Exactly what I was looking for. Printed in polymaker abs
Biqu H2 v2 for Ender 3 V2 mount and cooling system
Everything needed to use the Biqu H2 Direct Drive on the Ender 3 V2
In the contest Mechanical Marvels
86
479
6
3034
updated February 23, 2023
Makes
Comments
I don't know how long it will last so close to the hotend, mine is printed in ABS, but for now looks OK and working OK.
The actual print was great and i think this cooling duct is a great idea. However i will probably try something else soon because on my H2V2 (non-s) the height difference between nozzle and duct is tiny and there is no obvious way to adjust it.
I'm not sure if there is something different with my extruder or something wrong with my print but I've scratched prints of the print bed with the duct if the first layer is anything but perfect.
Do you have the ofset for probe any chance?
@sn00ka_517459 Sure theoretical offsets are:
X: -45mm
Y: 1.4mm
does the cr mount work with a bl touch aswell?
@sn00ka_517459 Yes I've sinced moved to a BL touch
Bonjour
Est ce que je pourrais avoir la reference du ventilateur s'il vous plait ?
@MatthieuBatar_492546 it's a standard 5015 blower fan. They are widely available on Amazon, AliExpress and local shops.
Beautiful model, works flawlessly. The Air jet is a little bit biased towards the back tho, but I haven't fully tested it's capabilities yet
@PieroVermigli_397286 Looks amazing in red. Hope it's ABS or ASA. Yeah it has a rear bias it helps with flow if there's a small bias. but the convergence should be directly under the nozzle.
