Nozzle Kit (plus cleaning and removal)

parts required 7mm hex socket for 1/4" square connector

A compact grab-and-go kit for all your nozzle needs.

Built in Nozzle Cleaning and Removal Tool.  The cap accepts a 7mm hex socket, so you can use it to remove the nozzle from the printer.  It is recommended that you put an extra hex nut into the socket when removing the hot nozzle; this is to stop the hot nozzle dropping directly onto the plastic needle guide.

It is difficult to thread the acupuncture needle into the printer's nozzle.  The cap also have a needle guide, so that it lines up the acupuncture needle perfectly with the nozzle hole.  Just move the cap with the socket over the nozzle, then push the needle through.

Plenty of storage for replacement nozzle.  Plus other bits.

Special Acupuncture Needle Compartment.  So they don't get bend out of shape by all the other bits.

Printing Notes

When printing the body upright, you might like to add a bream to reduce the chance of the print falling over.

If you choose to print the version with keyring, you'll need to have support acupuncture needle compartment.

The hole for the acupuncture needle may become block up in the print.  I have included cap with different hole size for you to try.  The 1.0mm one worked on my Prusa MK3S

Model in pictures printed in ABS.

You can check out my other prints at https://www.prusaprinters.org/social/76585-highrise-workshop/prints.  And don't forget to click the “Like” button.

designed to hold nozzle and bits