Solder Helper - Reduced Size

This helper holds two wires together so you can hold the solder and soldering iron. This is a remix of a great design by PeterLandin. I needed something a bit smaller, so I reduced the size and added a couple more slots for various wire thicknesses. 

The top of the wire slots measure 1.0, 1.5, 2.0, 2.5, 3.0mm. 

The base measures 38 x 50mm and overall height is 25mm. 

Each tower is 12mm wide with the gap between being 20mm. 

Print time was about an hour for 0.25 layer height and 15% gyroid infill.