Honeycomb Guitar Body

This is a Fender Stratocaster-based body with a honeycomb pattern design on one half of the body.

There is the model combined as a whole, but there is also a model of the guitar split into 7 pieces to fit onto print beds, with a channel along each of the slices in the body for some form of adhesive. I plan on combining these prints with friction welding. 

This specific model has cutouts for an input jack, pickups, and other electronics in the body. The electronics I used for this was a loaded pick guard that I found online, that had all of the electronics already built into it, then a separate input jack to connect to the rest of the electronics. As for the neck, I bought a relatively inexpensive replacement Strat neck online.

If you're looking for a good tutorial on friction welding, this is the one that I learned from: Finishing and Post-Processing 3D Printed Objects | Make

Note: This model hasn't been fully tested and put together yet