HyperX QuadCast Microphone Horizontal Adapter (V2)

I found the height of the QuadCast on the stand to get in the way of my monitors. This makes the overall height much lower, and allows for more clearance under the stand if you want to bring it forward under your keyboard.

Uses all the original hardware, so no additional or spare parts!
 

Note: if you have the old model that doesn't have the notches used in my version, check out this remix

https://www.printables.com/model/424206-hyperx-quadcast-microphone-horizontal-adapter-v3-s

Printing Tips
Print with high infill (I did 80%), and at least 3 perimeters.
Supports on build plate only, (or custom supports)
A few layers of raft might also be a good idea.

You could also “cut” the  v1 design around .7mm or so to allow for a nice flat print surface, but I wanted a rounded back. Let me know in the comments if there are any variations you'd like to see. V2 is flat and prints much easier.

Support enforcer on the lowest bridge should be all you need (see 3mf)