20x4 LCD Housing for 18mm MDF

20x4 LCD housing

Use M2.5 bolts to screw it in, can drill out for larger M3 if required as bosses are large enough to take it.

Designed to hang on the top of an 18mm MDF edge and for the cabling to be taken through the MDF at the rear.

Use small wood screw to secure if required, although it should be a good friction fit too.

I printed face down to get smooth front and minimise support required.

Use supports everywhere when printing.

Print Settings

Printer:

CREALITY CR10

Rafts:

Doesn't Matter

Supports:

Yes

Resolution:

0.2

Infill:

15% or more

Notes:

Print face down to minimise volume of supports required.
Will need to drill out support from the inside of the bosses.