Case for Amiga KMTech mouse joystick switcher

i couldn't find a case for the KMTech Amiga auto mouse and joystick switcher, so i had a go at making my own. 

this is a fairly basic case that has a pair of light pipes in the lid for the leds that indicate which port is active. there are blanking plates inside the lid to prevent light bleed from one side to the other.

printed in PLA+ 0.2 layers. for best results on the light pipes, use a clear filament.

for the pipes, i set 2 top and 2 bottom layers, and zero infill.
print with a brim for adhesion, then glue the pipes into the lid.

the lid will also require gluing down once everything is installed.
i used 4 small dots of superglue on each corner of the box.

one thing to be aware of, this case will probably require you to use a small extension DB9 cable. I got them off AliExpress cheap. 10cm is enough, but longer will also work.