Bed Levelling Test Print (200mm x 200mm)

I put together this quick, single layer test print to test the levelling setup of my Creality Ender 3 v2, with CR Touch. The model consists of a 0.2mm thick pattern, that is designed to be printed as a single layer (with matching layer thickness of 0.2mm).

This model can be imported into your slicer of choice, just be sure to set the layer height to 0.2 and add any required levelling gcode to your custom gcode.

The provided gcode file is for the Ender 3 with PLA (Creality PLA) and completes the following before printing:

• Sets the bed to 60C and the tool to 150C (to prevent oozing)
• Waits for the bed to heat up, and then waits an additional 30 seconds for the bed to expand
• Auto home
• Runs auto-levelling
• Sets the tool to 200C, and waits for it to heat up