Fr :
J'ai trouvé que le fan duct d'origine de la hornet n'était pas très efficace je l'ai donc redessiné afin d'avoir un refroidissement optimal !
il faut l'imprimer sur la face avant et pas besoin de support !
Privilégier un remplissage de 100% le pla fonctionne très bien avec !
édit 25/11/2021 :
je viens d'incliner de 10 degré les conduit, j'ai donc ajouter un nouveau fichier avec cette modification et un autre avec l'inclinaison mais sans les inscription
En :
I found that the original hornet fan duct was not very efficient, so I redesigned it for optimal cooling!
it must be printed on the front side and no support needed !
Favor 100% infill, the pla works very well with it !
edict 25/11/2021:
I just tilted 10 degrees led them, so I added a new file with this modification and another with the tilt but without the inscriptions
Printer:
Hornet
Rafts:
No
Supports:
No
Resolution:
200
Infill:
100
Filament:
PolyMaker playellow
Category: 3D Printer AccessoriesThe author marked this model as their own original creation. Imported from Thingiverse.