This is a support that I designed to hold my "Universe sphere's". It is designed to hold a sphere of about 72mm in diameter and site on a light source that is in a box about 62mm on edge.
Rafts: No
Supports: Yes
Resolution: 0.1
Infill: 20%
Notes:
Requires supports to enable the legs to be printed. For this model I have also enabled a "Support Interface" of 0.4 mm so that the base of the model is relatively smooth. This works because it is such a large flat area to be supported
The author marked this model as their own original creation. Imported from Thingiverse.