Taken Influence from https://www.printables.com/model/46707-simple-pliers-holder, but is a complete remake from the ground up. Including an 8 degree angled base to help removal of pliers rather than flat to wall
I used Onshape to design. Believe you have to have account, “but it is free”. You can change as you wish, I believe with link below. Just copy model into your account to change.
The STL file attached is of the second one listed below.
The picture shows two subtly different sizes. Both 1.8mm wall.
Settings used below on a Sunlu Filament.
The author marked this model as their own original creation.