I lost my long stick for my Elite Series 2 but had lots of the short ones. I took the rubber nub off of a short stick and 3D printed a new, long stick. Replaced the nub over the 3D printed stick and then I push fit it on to the Elite Series 2.
Prints on its thin end with supports to allow the curved thumb area to print nicely.
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
Yes
Resolution:
0.3
Infill:
20
Filament: Prusa PETG Orange
Notes:
Prints on its thin end with supports to allow the curved thumb area to print nicely.
Category: Video GamesThe author marked this model as their own original creation. Imported from Thingiverse.