Gotrax GXL v2 electric scooter hidden AirTag holder

Easy print, no supports. Screws right in under the rear fender. Attach with 20mm M4s
In the contest AirTag Accessories
8
61
2
931
updated August 19, 2022

Description

PDF

Simple model, no supports.  I think it should hold up fine with any filament.

I printed it at .3 layer height 20% gyroid infill in PETG

I printed the version with the bigger holes. The side with the holes closer to the edge will face the front of the scooter. (It is obvious when installing it.)

I created another version that has an arrow to make it easier.  It also has hex shaped holes because I was thinking that might help with adhesion. 

  
Attach with 20mm M4s.

Tags



Model origin

The author hasn't provided the model origin yet.

License