Handle for Samsung Galaxy TAB A7 and A7Lite

I struggle with holding my tablets while reading books.  The tablets are too slippery to hold without the cover, the very thin border causes pages to change because there is not enough room for fingers without the sensor flipping pages, and the included covers are not for holding but just covering and acting as a table stand.

The included files are for Samsung Galaxy Tab A7 Lite (2021-2) and Tab A8 (2019).  I have included the gcode files I used on my MK3s. They are just .3mm draft versions, so come out a bit rough.

There are two versions, one is split into two parts, and prints an hour and 20 minutes faster than the single piece version.  The handle on the single piece version looks better, but cleanup of the support is a pain.  The single piece version requires support.  The two part version does not.

The handle is in the middle and works fine right or left handed.