When I load in to the slicer it keeps trying to print without the hex pattern and just printing the outer edge.
Xbox Stick Savers
Helps prevent movement (and hopefully damage) while transporting an Xbox controller in a bag
56
289
8
2223
updated August 1, 2022
Makes
Comments
@MrMiles_3025587 Do you have any options set in your slicer that increase hole sizes? The walls of the hex pattern are only .5mm wide, so it wouldn't take much for those to end up excluded from the gcode because they end up thinner than your print nozzle.
Works great. It really helps keep the sticks in place. Printed in PLA and works as intended
Great design. Took about 1 and a half hour to print in PLA with the recommended 100% infill and 0.2 mm layer height.
These work great. Printed them for all m;y controllers.
I know it said xBox, but I tried them on my PS5 controller. They work but they're a little tight. I recommend if you print these for PS5 that you increase the size by about 5%. Otherwise, these are quick and easy!
Printed using "Wine" PLA from Overture3D. (edited)
