Orbiter Fennec

Parts List:
5015 Fan * 2
4040 10 fan
M4 nuts * 2
M4 bolts * 2 max length 20mm min 10mm
M3 bolts (from stock machine) * 8: Two for mounting onto x carriage, 4 for mounting the fan Max is 12 mm in length

M3 Heated Inserts *2
Optional
BL touch, plus mounting hardware
 

Printing tips:

Supports: required

For the fan ducts, use the flat face on the top of the duct so that the duct stands vertically, other orientations can work, but it is more consistent this way

Build guide

Place the two Heated inserts into the furthest back holes on the top set of arms

Remove everything from the x carriage, and mount the back plate

Install the hotend, and place the two m4 nuts into the little slots on the upper arms

start to screw in the M4 nuts into the holes on the top arm. 

Take the two fan ducts and place the slots around the head of the m4 bolts

For Bl touch: 

Take the cover plate and mount the Bl touch to the two holes make sure the connector for the bl touch is facing away from the hole in the center of the cover plate

X offset: 45.65

y offset: 5.67

Your z offset is going to vary greatly, depending on hotend choice and your nozzle choice, a recommended starting place is going to -4.5

Take the 40 mm fan and 4 m3 bolts and thread it through the cover plate.

This is the last point to adjust the Fan Duct height

Insert the ptfe tube into the hotend, Line up the orbiter to the tube and slide down until the orbiter is touching the mounting arms, and screw in the m3 screws through the orbiters mounting holes

take the cover plate and screw in the 4 bolts of the fan. After those 4 bolts are tight, screw in 2 bolts into the top two holes, there might be some misalignment, this is normal

Have fun Printing