Just a case for a 128x64 0.96 inch OLED I2C/SPI
You may want to clean it up a bit, but for me it fits perfectly off from the printer.
The OLED Module i use is from AZ Delivery, but they just sell rebranded stuff, so it should be pretty much the same as all these chinese 128x64 OLED modules.
Be sure the solderpoints are not higher than the glass of the screen, use a sidecutter to make them lower ^^
Printer:
Voxelab Aquila
Rafts:
No
Supports:
No
Notes:
Print with 0.4mm wall thickness
Category: HobbyThe author marked this model as their own original creation. Imported from Thingiverse.