RaspberryPi 3B Case

This is a remix of Suraki's RasPi case (https://www.thingiverse.com/thing:710688), with an additional version for OctoPi Octoprint servers.

There are locating holes on the logo pieces that match locating pins added to the case tops.

If you're using an easy to glue filament type, add a drop of glue to each pin to secure the logos. My preferred method is to melt the pins to hold the logo in place. I use a common nail stuck in a short piece of bamboo heated over a candle. You can also use a soldering iron or a 3d printing pen.

I also added a stand to hold the Pi vertically.

Print Settings

Printer:

Prusa Mini

Rafts: 

No

Supports:

No

Resolution: 

200

Infill:

20

Filament:

Duramic 3D PLA

Grey, Red & Green

Category: Computer