Probe Holder Modular

Probe holder that gives you choices.

Main body tilts the probe out allowing for easy thumb access from top, while still leaving side to side and top to bottom ways to extract the probe from the mount. The tilt was a desire after printing the other probe holder listed, as extraction/replacement when not looking sometimes had me dropping the plate.

I have 2 versions, one with and without the magnet holder, as if you have a spindle that is properly grounded, the magnet is no longer needed. I have also added a separate print for just the magnet holder that can be glued anywhere on the body as preferred.

All stls are in a good orientation for printing.

Print Settings

Printer Brand:

Prusa

Printer:

i3 MK2S

Rafts:

No

Supports:

No

Resolution:

200

Infill:

20

Filament: Generic PLA