Fire TV Remote Cover

Slice print sand down the brim area works like it should.

New to this so pardon the beginner question, is the downloaded file the only file needed to send this to print? I know certain printers have different slicers, but will this file load into a slicer and be good to go?

The original cover was continually falling off. This replacement printed cover is a big improvement. Printed in PLA at .2mm layer height. On reflection, a finer layer height may provide an even better fit, which I may try in the future.

Printed in PETG with .2mm layer height, standing upright, no supports. Fit perfectly. Snapped into place.

ciao vorrei stamparlo ho cercato per lungo un tappo normale senza prolungamenti o cose del genere vorrei sapere due cose prima di stamparlo
1) ha bisogno di supporti per essere stampato ?
2) ho letto un commento che non si adatta e davvero cosi o e solo un suo problema perché forse lo ha stampato male ?
grazie a tutti

Not a 1:1 but perfect for the use case of "kids lost the back of the fire tv remote...again."

This print did not fit my fire TV remote :(

I’m not 100% sure why… but it looked like the little tabs on the back were not the right size. Maybe I have a different version of the remote?

Bright Yellow. works perfect. The back stays on. Printed in bright yellow so I can find the blank remote easily.

I printed at 0.3mm in PETG. Just to see if it fit my remote. It does fit but would recommend printing with finer layer height.

Hello! Can u share the 3D CAD model?
I need to make a small change to fit my controller perfectly.
Thanks.

How in the world did you measure and get this into CAD? I had such a hard time with my Fire TV Remote project. Just endless test prints and guessing.

It was a touch too long and I had to file it down. It's staying put though...more than I can say about the factory one!