Lid

Note that the lid in the picture is sliced in Cura with the “Make overhangs printable” setting enabled, the model have quite steap overhangs wich problably will be hard to print as is.

I have added a v2 of this model that is not rounded and thus has no overhangs.

Lid to keep all the caps in place when storing. 

It is designed to be a exact fit to the board so depending on printer and slicer settings it might become either too tight or loose. Printed on my Ender 3 with a 0.8nozzle and sliced in Cura with Slicing tolerance set to “Exclusive” it made a perfect fit.

The overhangs in the bottom might be a bit to steep, printed well with the Cura setting “Make overhangs printable”.