Pico boot stand mount bracket for GameCube mod

Here is a friction fit stand for mounting a Pico inside a GameCube console next to the fan.

The stand has option to use M2 x 5MM screws to secure the pico into the mount.

The mount fixes into the gamecube using an original screw found in the installation location, simply remove the original screw, put the bracket into place, and screw the original screw back in to secure the mount.

Tested with official Raspberry Pi Pico board.

UPDATE: 01/0//2022

New remix uploaded (remixed and provided by AmyGrrl) to add support for Pico W. AmyGrrl added a small internal pocket hole to allow room for SMD components that would be incompatible with the original stand design.
 

Printed in ABS is probably recommended due to potential heat inside of a games console.

Thanks goes out to @webhdx for his amazing work releasing this pico mod, you can find out all the information on the picoboot project on github:

https://github.com/webhdx/PicoBoot

Please consider donating on github to webhdx, the creator of Picoboot.

You can purchase this mount printed in ABS from https://www.zedlabz.com

All of the parts needed to install this mod including official Pico boards are available from https://www.zedlabz.com