Knife separator

I use a lot of these very sharp 80mm knives in my kitchen and you need a lot of attention if you want to get them out of the drawer…

So I made this little 80x70x16.5mm knife separator for up to 6 knifes to put into the drawer that will sort the knifes and will hide the knife blades inside it.

The gap size is 2mm for the blades to have enough space.

The separators on the outsides are 5mm and between the knives are 9.6mm space to give the handles enough room.

Printing instructions:

• 0.3 speed profile 
• 10% infill
• Brim set to 5mm
• No supports needed

Happy printing :)