VTOL VR Flightstick

VTOL VR JOYSTICK A desk mounted VR controller dock/joystick for VTOL VR. The design allows the physical joystick to be…
61
96
0
2847
updated July 12, 2022

Description

PDF

VTOL VR JOYSTICK

A desk mounted VR controller dock/joystick for VTOL VR. The design allows the physical joystick to be in the same location as the stick in the game and to not interfere with using the MFD’s and control panels.

Rubber bands tension the joystick in pitch, roll, and yaw axis.

Clamps to your desk for easy installation and removal.

Printed Parts:

  • Desk Clamp Jaw Top
  • Desk Clamp Jaw Bottom
  • Desk Clamp Screw
  • Desk Clamp Pressure Plate
  • Hotas to 20mm Extrusion Adapter
  • 90 Degree Adapter
  • Joystick Base
  • Joystick Rubber Band Washer
  • Joystick Handle
  • Controller Adapter LEFT
  • Controller Adapter RIGHT
  • 4x 10mm End Cap Stop
  • 4x 10mm End Cap
  • 2x 20mm End Cap

Required Hardware and Accessories:

  • 10mm Ball Stud M6 Threads Amazon
  • 10mm x 5mm Magnets Amazon
  • 8x Nylon Screws 1/4x20 Thread Hardware Store
  • M4 x Screws Assorted Lengths Hardware Store
  • M4 T Nuts for Extrusion Amazon
  • 014 Orings ( ½ ID ⅝ OD ) Amazon
  • Rubber Bands Wallgreens
  • 10mm Carbon Rod Amazon
  • 20mm Extrusion Amazon

ASSEMBLY INSTRUCTIONS

Use a hammer to gently tap the ball stud into the socket.

String the rubber bands on the washer using the pictures in the assembly folder.

The orings can be a pain to insert into their groove. A small tool can help make it a little bit easier. They are there to keep everything tight and quiet.

The desk clamp has holes for some 1/4x20 Allthread. Use lock washers and acorn nuts on the top and bottom. The allthread keeps the layers of the clamp from separating. I printed this part in PETG for better layer adhesion as well.

Once its all assembled use the nylon screws to secure and tighten everything. DONT OVERTIGHTEN, this will break the carbon rods.

Update 04/21/2022

I split the desk clamp jaws into two files. You will need 1/4 inch allthread and some washers and nuts to put them together. I had to do this to keep the layers from coming apart when clamping and also to make it much easier to print.

Print Settings

Printer Brand:

LulzBot

Printer:

TAZ 6

Rafts:

No

Supports:

Yes

Resolution:

0.2mm

Infill:

Yes

Filament: Any PLA, PETG for the desk clamp Post-Printing =============

Joystick Base and Handle. Rubber bands on Washer

Fully Assembled Joystick

Desk Clamp Before Assembly

Desk Clamp Assembled

Category: Toy & Game Accessories

Tags



Model origin

The author marked this model as their own original creation. Imported from Thingiverse.

License