FeelWorld FW568 5 1/2" inch Field Monitor Shade

FeelWorld FW568 5.5 inch Field Monitor Shade

No screws, sticky stuff, etc, except for double-sided tape (or general-purpose glue) to stick some black felt to the inside of the shade to kill reflections. Alternatively paint the inside of the shade matt black.

The shade just pushes onto the thin rim round the screen.  Peel off the hook-and-loop (Velcro) strip from the monitor and the sticky stuff below it.  The shade presses firmly onto the monitor with no further embellishments.  Easy to remove - just pull it off for storage. Doesn't interfere with any functionality.

Instructions:
Use the gcode file or print from the STL file with:

PETG (Prusament Black recommended)
NOTE: The files are pre-scaled 101% for a perfect fit.
0.4 mm nozzle
0.15 mm layer height
25% infill (doesn't really matter)
5 mm brim (just in case it wants to part company with the print bed)
No supports

The files are orientated with the correct face on the print bed.

It will take a while to print (about 6 of your Earth hours) but is a vast improvement over the sh*tty felt-backed plastic thing that FeelWorld supplies.

When you pull the shade off the print bed, you'll need to remove the brim with a sharp blade and clean up the inner channel all the way round (both inside edges).

This object was designed in SOLIDWORKS.

Regards, Paul.