Saw a Commander Deck box posted to http://www.reddit.com/r/3DPrinting, but the original user deleted the post.
Thus I took it upon myself to recreate it from scratch and adding in some neat things while I was at it.
This is a deck holder for Magic: The Gathering, specifically for the Commander Format.
Features:
Magnetically held together with 8x 5x3mm neodymium magnets.
Link for magnets: https://www.amazon.com/5x3mm-Personalized-Multi-Use-Whiteboard-Refrigerators/dp/B078HTF489/
(small side note, you can also use 6x3mm magnets for a more snug fit)
Versions of each lid and bottom for each of the mana types.
These can be mixed and matched depending on the mana at use in the deck.
There is a slot in the front of the box that the commander can be placed in.
(Commander Card must be double sleeved to fit in slot properly)
Planeswalker logo on all lids
Blank version of lid and bottom added if you want to add your own symbols.
All source files included for ease of modification:
STL Files
STEP Files
F3D Files
If there is a version you would like that is not listed please post a comment and I will upload in whatever format you need.
UPDATE 10/11/18 - Uploaded V2
Changelog:
Increased width of card slot to enable easier insertion of deck when they aren't perfectly aligned
Changed orientation of the cutouts for your fingers to grab the cards; much more comfortable to grab them front-to-back
Increased top wall in Commander card slot so there wasn't such a large gap on top of the card
If anyone wants the original versions please leave a comment and I will upload them somewhere.
Printer Brand:
Prusa
Printer:
i3 MK3
Rafts:
No
Supports:
No
Resolution:
Doesn't Matter
Infill:
100%
Notes:
Orient parts so when printed the top and bottom of the box are on the build plate. This way no supports are necessary.
Add Magnets
Check orientation of magnets PRIOR to gluing in.
Take 8x magnets and make four pair.
Then put a dot of cyanoacrylate in each of the 8 corner holes, and place the magnets inside. Then press against a flat surface and wait for it to cure.
PLEASE NOTE: The hole is a 6mm hole, this gives a .5mm gap all around the magnet for CA glue so you can 'pot' it inside the hole to ensure it will not come loose.
Used the Original STL provided in the reddit post:
Imported into Fusion 360
Disabled Capture design history
Mesh>BREP
Gathered critical dimensions of box
Opened new F360 document and using recorded dimensions recreated from scratch.
Added Mana Symbols to all lids and boxes
Added Planeswalker logo to lids
Added fillets to top and bottom surfaces, as well as the four corner 'posts' to increase strength.
Category: GamesThe author marked this model as their own original creation. Imported from Thingiverse.