Small Vase with Filament Decoration

It is just a small vase, nothing special. The size is ~Ø80 x 100mm.

Print it, put a flower in it, admire it.

To make the vase waterproof print it with 3 walls and 0.2mm layerheight (or smaller). If your print is still leaking water, spray clearcoat inside the vase. This will seal all leaks.

The design is meant to be printed with a 0.4 nozzle. Support is not necessary.

After printing you can decorate the vase with a 1.75mm filament. Slide the filament through the holes in the bottom to the top of the vase. Use a hot air gun or a hair dryer to force the filament in shape. Finally lock the filament in posiiton by gluing it to the bottom of the vase.

Disclaimer:
This work by blecheimer is licensed under CC BY-NC-SA 4.0
You are not allowed to copy this model to other 3D printing websites without my permission.