Used to route cabling upward
Voron Trident A Drive Cable Cover with PG7 Cable Gland
Simple replacement cable cover for the A drive of a Voron Trident to accept a PG7 cable gland for a CAN umbilical
174
1157
7
7446
updated July 4, 2022
Makes
Comments
Hey! Any chance you could provide me with a link for the a drive frame with the y endstop embedded in it for the trident? Thanks!
@Zoomer_1300043 Sure thing/ Thats the 'standard' hartk y-stop relocation: https://github.com/VoronDesign/VoronUsers/blob/master/printer_mods/hartk1213/Voron2.4_Trident_Pins_Mod/STLs/Gantry/AB_Drive_Units/Trident/a_drive_frame_upper_with_jst_y_endstop_pinned.stl
I needed a connector for pg7, so I cut off the bottom in Prusaslicer, printed it, and screwed it onto the RPI3B+ Hyperpixel enclosure (with some additional superglue). Printed with Polyterra Lava Red, 50% infill, 0.2mm
 https://www.printables.com/model/107548-raspberry-pi-32-octopi-case-with-hyperpixel-touch-/comments#comment-921855 (edited)
@collab Creative use of the model, nice - thanks for sharing
the mount works great on my trident but now I'm trying to figure a way to get the cable sleeve to stop scratching my top panel
View one more comment
@Elricdmaxx_296270 Hi, I have pin mod, if this is what you are looking for, here it is https://github.com/hartk1213/MISC/tree/main/Voron%20Mods/Voron%202-Trident/2.4/Voron2.4_Trident_Pins_Mod/STLs/Gantry/AB_Drive_Units/Trident
@Oldbalon_277387 Great pic! I'm looking for that bolt-on PG7 holder, the one with the two screws into the orange piece. Know where I can find that?
Could you provide sourcing information for the cable and gland?
@opinion_panda The PG7 strain relief is from AliExpress (but can be bought from Amazon as well, just use that search term): https://de.aliexpress.com/item/4001159023849.html
The cable depends on the can board used, I'm running first gen SH36/42 boards on some printers for which I use the proper molex overmolded cable bought from DigiKey: https://www.digikey.de/de/products/detail/molex/2451320430/6822829
The the newer SB2040 (split) boards do come with a matching cable which I just sleeve.
Would you be able to make another version which works for PG9 mount? My umbilical is a non-CAN implementation so the wire is pretty thick.
Hi, thanks for this mod. Could you possibly post a F360 or STEP?
