I was asked to print https://www.thingiverse.com/thing:2176304 but PrusaSlicer wouldn't correctly slice it. Instead I drew this in Fusion 360 based on the picture.
It printed nicely although maybe its a little small. Might be worth stretching in the X & Y directions.
The walls and floor are only 1mm thick. It's probably enough but the Fusion360 file is attached if you want to make anything thicker.
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
180
Infill:
20
Filament: 3dk.berlin PLA Black
Notes:
My filament is old and brittle so I wasn't sure how well it would print. Apart from a bit of stringing it was fine though.
Category: OfficeThe author marked this model as their own original creation. Imported from Thingiverse.