I had to make this because the v2.0 Bumblebee and Green Hornet ducts are 2 mm wider and 1mm taller compared to the v1.3 ducts that are readily available here on Thingverse.
Printer Brand:
FlashForge
Printer:
Creator Pro
Rafts:
Yes
Supports:
No
Infill:
100%
Filament:
Hatchbox? PLA
Notes:
Print upside down (with the notches up) and it won't need supports. All 3 notches are the same size (the OEM ones have one notch that's deeper than the other 2). I've found that using a raft keeps it from being knocked off the print bed.
How I Designed This ===================This also was my first build using Fusion 360 instead of Tinkercad. I'm very much still learning which is why all 3 notches are the same size, I did manage to figure out how to make the duct roughly shaped the same as the OEM one: narrower at the top and wider at the bottom. Dunno if that serves an actual purpose or not =)
Category: R/C VehiclesThe author marked this model as their own original creation. Imported from Thingiverse.