fits well and will be very practical because of the possibility of removing the holder.
I just have to find the ideal installation location.
Thank you very much!



fits well and will be very practical because of the possibility of removing the holder.
I just have to find the ideal installation location.
Thank you very much!
Nice design. Maybe you could consider making a variant for the popular Wera hex key set? Those have round shafts (only the ends are hex-shaped) (edited)
@The3Designer Cool :) I've just measured them and from small to large, the diameters of the shafts are (in millimeter): 4.05, 4.05, 4.05, 5.05, 6.25, 7.65, 8.65, 11.85, 13.85. So 9 hex keys in total.
There is a bit of variation on them, as they have this plastic housing around the shaft which isn't 100% uniform, so maybe a bit higher tolerances are needed than with a metal shaft.
I'm happy to do a test print if you want to check the fit before actually uploading!
@ValtaStudio_134975 Thanks for the measurements! I'll DM you for the prototyping when I have a finished model. This will probably be upcoming week :)