Apple Watch Charging Stand

I small print to give my Apple Watch (44mm) a better home on my nightstand.

The design allows for the cord to go to the left or the right. On my print, Apple's magnetic charger fits perfectly in place, which is then snug against the watch as it should be.

Print instructions

Category: Household Print Settings

Printer Brand: Prusa
Printer: I3 MK3S
Rafts: Doesn't Matter
Supports: No
Resolution: 0.15mm
Infill: 15%, 50%
Filament: Prusament, Mika3D PLA Galaxy Black, Silver Silk

Notes:
Base is Galaxy Black. It prints flat on its bottom.
Upright portion is Silver Silk, prints with its back against the build plate.

No supports needed.

I printed the base with an infill of 50% just to bring the weight up. ~30g. Gives a nice solid feel that won't topple over so much.

Post-Printing

I modeled in 2 small 2.9mm in diameter and 8mm deep holes for small cabinet screws to hold it together. Not strictly necessary though.