USPSA/IPSC Adjustable Magazine Carriers

Adjustable magazine carriers for USPSA/IPSC belt rigs. Mounting to a TekLok-compatible clip (consider the PipClip, also in my designs, for a printable option), they can be adjusted for camber and toe, to allow tuning of wrist and arm angle across your entire belt.

Supports bullets out as well as left- and right-hand bullets forward.

Comes with five sizes of pouch for common sizes of magazine:

1. Single Stack: single-stack 1911 magazines. Inside dimensions 13mm×35.25mm.
2. Small: Beretta 92/CZ-75 size. Inside dimensions: 21mm×32mm.
3. Medium: CZ P-09 size. Inside dimensions: 22mm×32.5mm.
4. Large: Glock size. Inside dimensions: 23mm×33.5mm.
5. XL: double-stack 1911 magazines. Inside dimensions: 23mm×35.25mm.

For best fit, measure your magazines, print the next largest pouch, and use a screw through the front of the pouch to adjust retention to your preference.

Assemble using M3x25 cap screws and nuts.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

No

Supports:

No

Resolution:

0.2mm layers, 0.4mm nozzle

Infill:

60% cubic

Filament: eSun PLA+

Notes:

Print belt plate laying flat.

Post-Printing =============

Hardware

Press the body and belt plate hinges together. Run a 30mm M3 cap head screw through them, adjust, and tighten down against a nut in the captive pocket.

If extra retention is needed, run another 30mm M3 bolt through the clamp at the magazine pouch's opening and tighten until sufficient retention is attained.

Category: Sport & Outdoors