As I have my printer on short table, the screen was sticking out and was being hit sometimes when passing. With this design solved this problem and used the "useless" space between the bed and the left z motor, killing two birds with one stone. Thanks for sharing!
@MarcBres glad you liked it. The overhanging display was exactly my issue.
Thanks for posting your make.
Can you provide a longer slider? So that i can basically turn it 90 degrees to the front if needeD?
@frei7_100386 I am sorry, but when I made a longer slider, it was not strong enough to take the additional force.
@AHPrusai3MK3SKit Can you provide the file in step or so anyways? Thx
@RobertoScarpa_346091 thank you for your response - The main aim for the design is to allow the display to be moved from the front position to either left or right and allow a small amount of adjustment. Increasing the adjustment angle would create a very weak model and so I only created a small amount of adjustment.
@DOMELL Glad you liked it - side position of MK4 display seems so much better and takes up less space :-)
@Emjay_86080 Glad you liked it, thank you for posting your make.
@Martin_1461703 great print thank you for posting.
Really pleased that you found it useful.
Great that you could also use the spare hardware.
Exactly what I needed to give myself just a wee bit more Y-axis room in my enclosure.
Printed off all the parts at the same time and they came out great! Installation was easy with the pictures and steps provided on the print page.
@Solphaen thanks for the comments and for posting your make glad you liked it.
Easily printed. My first actual print on my new MK4, and it works quite nicely.
@DeliberateGee_143391 looks great, thanks for showing your make
@APtech Brilliant post, thank you for showing your make. I have updated the print to show MK4 compatibility.
@Lali3d thank you for posting your make.
THE BEST way to side mount your display for the MK3S that I have seen so far. Thank you so much for this print. I have limited space and this 100% pulled me out of a tough spot.
@AHPrusai3MK3SKit parts replaced with PETG. I didn't have any 30 mm M3 screws on hand so this will work for now. I'll have to worry about that later.
I did 100% infill also. Still one of the best mods I have for my printer's angled situation. :)
@Pluto3301 - i hope this proves to be stronger for you. Thank you for the feedback
@marcomania_128182 thank you for posting your make.
