A printable bung to put in the cover of your Type 2 cable to stop it from filling with water while charging (This is only the smaller end designed to go into the charger, as the car end can be tucked inside the charge flap usually).
Big thanks to Schuzi for posting his plug cover which I used as a negative for this bung.
(I used Tinkercad)
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
30%
Filament: Eeryone PLA White
Notes:
Use at least 30% infill, I used 20% and its a little too flexible for me (its quite a tight fit).
I used PLA however I recommend ABS/PETG as this will be used outside in bad weather.(but I'm a newbie so haven't learnt the different settings for ABS/PETG yet!)
Category: AutomotiveThe author marked this model as their own original creation. Imported from Thingiverse.