TurboGrafx-16 MINI Portable

The front and back shell are printed with PLA at a resolution of 0.2 with supports.

Here's a list of parts used if you want to source them yourself:

1. TurboGrafx-16 Mini system - these are out of print but can be found on 2nd hand markets. Prices are going up though. 
2. PLA filament (I used OVERTURE brand) - https://www.amazon.com/OVERTURE-Filament-Consumables-Dimensional-Accuracy/dp/B07PGYHYV8/
3. 4" HDMI IPS LCD - https://www.amazon.com/gp/product/B09QVD3HLD
4. 3.7v 4500mAH Li-ion battery - https://www.amazon.com/gp/product/B07TTD2Y5G
5. HORI PS4 USB controller - https://www.amazon.com/gp/product/B075Q5YMHM
6. Li-ion Step-Up Battery Charger (set to 5V) - https://www.amazon.com/gp/product/B08GWTBD3T
7. 2-position slide switch - https://www.amazon.com/gp/product/B07XSJYYYB
8. Flat HDMI cable - https://www.amazon.com/gp/product/B07R5JPTDB
9. Flat USB cable - https://www.amazon.com/Ribbon-Degree-Standard-Receptacle-Charging/dp/B07WZV9XV9
10. 4-Pin connectors (to connect speakers to the LCD) - https://www.amazon.com/gp/product/B08RHGT3W
11. 2-Pin male/female connectors (optional) - https://www.amazon.com/gp/product/B013JRWCBU
12. 30x30x10mm blower fan (optional but I found the battery charger getting very warm so this is probably a good idea) - https://www.amazon.com/gp/product/B07RMGVBKL
13. Two 30mm x 25mm (max) flat speakers (mine were taken from an old laptop but these should work if you glue them in place: https://www.amazon.com/uxcell-Speaker-Replacement-Loudspeaker-20mmx30mm/dp/B07M99X8GP or these if you slightly modify the case - https://www.amazon.com/MakerHawk-Full-Range-Advertising-Connector-Separating/dp/B07GJ4GH67
14. 3.5mm audio jack connector (optional, to access the headphone jack on the LCD) - https://www.amazon.com/gp/product/B016E5PEXC
15. The I and II buttons were taken from the original Mini controller. The D-pad from the HORI controller can be used. 
16. The Menu button can be made by cutting a GBA Start/Select button in half - https://www.amazon.com/Colorful-Conductive-Buttons-Gameboy-Silicone/dp/B07MZZWFP2
17. The Run & Select buttons I used came from a random pile of buttons I had but a reasonable replacement can be made by cutting a GameBoy Color Start/Select button in half - https://www.amazon.com/Replacement-Conductive-Silicon-Nintendo-GameBoy/dp/B07DY5VB9R