Dust Cover for "Schuko" Power Outlet

I remixed the power outlet dust cover by grumbel, because I want to swap it more often in and out.

I use it in the kitchen near the hot plate, where tomato sauce may be splashed or likewise. :)

Therefore the cover is a little bit thicker with some cut outs to pull it out more easily. I also adjusted the width between the springs to make it a little bit more loose.

There are two additional version:

Half and Small in order to cover the hole, which is left open in the Schuko outlet, when an Euro-Plug (Type C) is inserted.

There is also childproof version with less width between the earth-springs and without the grips. (basically back to the design idea by grumble ...)

I don't guarantee your child is not able to pull the cover out. Give it a try!

If you like the design a coffee would be great.

Print Settings

Rafts:

No

Supports: 

Yes

Resolution:

0.2

Infill: 

10%

Filament: PLA white

Notes:

No Support or special treatment for slicing needed