BMK Snap-on Magnetic Trim

06/21/2022 Update: Added models to print on smaller build plate printers like the Prusa Mini.

Trim designed for the excellent build-your-own mechanical keyboard and keypad (https://www.boltind.com) created by Ian at Bolt Industries.  This trim  does more than look nice.  With the addition of 6mm x 6mm magnets the keyboard and keypad can lock together.  If needed the magnets can be removed by pushing something (like a small Allen wrench) through the hole behind the magnet.  This is a remix of the decorative trim I designed ().

Assembly

• Insert the magnets into the keyboard and keypad trim.
• Loosen the screws holding the top of the keyboard and keypad on and then snap the trim to the posts.
• Where the two pieces of trim meet in the front of the keyboard and keypad, slot the triangle tab into the slot of the right-hand trim. 
• Once installed, tighten the screws.

Bill of Materials

8x 6mm x 6mm round magnets

Other BMK Prints

• BMK Snap-on Keypad Trim - https://www.printables.com/model/227224-bmk-snap-on-keypad-trim
• BMK Snap-on Keyboard Trim - https://www.printables.com/model/227221-bmk-snap-on-keyboard-trim
• BMK Attach Keypad to Keyboard Right Side - https://www.printables.com/model/229367-bmk-attach-keypad-to-keyboard-right-side
• BMK Attach Keypad to Keyboard Left Side - https://www.printables.com/model/229372-bmk-attach-keypad-to-keyboard-left-side