Kyosho Inferno ve center diff cover
Normal diff cover (To eliminate the wall from leaking oil increasing wall thicks is advisable )
Two types for the diff lock
-Type 1 uses M3 hex grub screw shaft.
-Type 2 use two M3 hex grub screw at each side and the original shaft in the middle.
Use 8x16x5mm bearing
Printer Brand:
Ultimaker
Printer:
Ultimaker 2
Rafts:
Doesn't Matter
Supports:
Doesn't Matter
Resolution:
0.15
Infill:
30-50
Filament:
General ABS
Notes:
Wall thickness 1-2 mm
Category: R/C VehiclesThe author marked this model as their own original creation. Imported from Thingiverse.