LCD Cover for Anycubic Kobra

General

I wanted to create another cover for the Anycubic Kobra that isn't print in place like my previous model - https://www.printables.com/model/175558-cover-for-anycubic-kobra

So decided to rework it a little bit with a 2 part print (door and casing). 

Improvements

• Door and case printed separately.
• The casing should go in deeper into the LCD screen 
• The hinge now uses a ball joint style 
• The door should now close completely instead of leaving a 10-15 degree opening

Print Information

• You can print the case in a bigger nozzle size to print faster (I printed with 0.8mm)
• I recommend printing the door with a 0.4mm (or lower but it might take awhile) to get the details
• I recommend using supports
• I recommend using a Brim to keep it from flexing off the heatbed (don't want a flex door now)

Misc

• Make sure to clean out the socket after print (stringing/oozing) to get a nice fit of the ball joint
• You'll have to apply a bit of pressure to get the door attached and once you get it in there, it's almost impossible to take out
• Make sure to trim/clean off the brim completely or your door might not close nicely