It adds PTFE cable guide to the platform.
4
17
0
651
updated February 6, 2023

Description

PDF

This is an add-on to the platform that I have created. It adds 6 mm PTFE tube as cable guide to the Sculpfun S9 laser cutter/engraver. It can be used with anything as long as it also uses a platform

PTFE holder have a slot for the zip tie to secure cables. There are platform adapters that have left and right side end stop, so the holder doesn't rotate too much, there is also an adapter without the end stop if You have enough space for cables to move over the machine sides.

Items needed [Sculpfun S9, all]:

  • 2x platform,
  • 10x M3x10 to secure holder to the adapter and adapter to the platform,
  • 1x M3 washer,
  • 4x PTFE holder,
  • 3x PTFE platform adapter [with 90 degrees end stop or without, You would need 1 left and 2 right to get full coverage],
  • 6 mm PTFE tube [485 mm X axis, 575 mm Y axis, 1060 mm total length] NOTE: it might be possible to use just 1 meter of the tube, currently do not have any more tube to check,

Items needed [any, each joint]:

  • 1x platform,
  • 3x M3x10 to secure holder to the adapter and adapter to the platform,
  • 1x PTFE holder,
  • 1x PTFE platform adapter [with 90 degrees end stop or without],
  • 6mm PTFE tube,

 

Tags



Model origin

The author marked this model as their own original creation.

License